LED strips are used in a wide range of fields. Different usage scenarios have different installation methods. When installing light strips, you should pay attention to the following 11 points:

1.The ambient temperature of the LED strip is generally -25℃-45℃

2.Non-waterproof LED strips are only for indoor use, and the air humidity should not exceed 55%

3.The IP65 waterproof light strip can resist the influence of the atmospheric environment, but it can only withstand a small amount of water spray on the surface for a short time, and cannot be used in an environment with a humidity exceeding 80% for a long time.

4.The IP67 waterproof light strip can be used indoors and outdoors. Colleagues can withstand the water pressure of 1 meter underwater for a short time, but the light strip needs to be protected from external extrusion and damage from direct ultraviolet rays.

5.IP68 waterproof light strip, can be used indoors and outdoors, and can continuously withstand the water pressure of 1 meter underwater, but the product needs to be protected from external extrusion and direct damage from ultraviolet rays

6.In order to ensure the luminous effect of the LED light strip, the longest connection size of the light strip is usually 10 meters. For the light strip designed with IC constant current, the connection length can be 20-30 meters, and the maximum connection length cannot exceed the maximum length. The length of the connection will lead to inconsistent brightness at the beginning and end of the light strip.

7.In order to ensure the life of the LED light strip and the reliability of the product, during the installation process, the light strip and power wire cannot be pulled forcibly.

8.When installing, you need to pay attention to the positive and negative poles of the power cord of the light strip. Do not connect it wrongly. The power output and the product voltage must be consistent.

9.The power supply of the light strip should choose a product with good stability, so as not to cause current and voltage surges to damage the light strip components due to unstable power supply

10.In practical applications, it is necessary to reserve 20% of the power supply to avoid damage to the light strip caused by synchronization after the power supply is overloaded.

11.The light strip will continuously emit heat during use, and the product must be used in a ventilated environment.